Saturday, August 12, 2017

Jib harken carbo foil replacement

Yesterday with the help of Clive we changed the jib carbo foil which got damaged two weeks ago when the A4 got tangled up in the forestay. We saved the A4 but the carbo foil got damaged and needed to be replaced. Fitting the new one was real hard, it simply did not feed in. We ended up using a hailyard to winch it up and also pushing by hand. We cut it at the same length 18.77m is the old one, but it's a bit short. It could be 20cm longer. The bottom should be 1.10m above deck.



The heat rising to 40C did not help, but it's in place finaly.

Engine reverse issue

In reverse only very little thrust is generated. According to Gori the blade angle in reverse should be 60 degrees, this is what we have about. It is as so the engine is not delivering enough revs.

The prop is here in reverse mode and the blade angle seems good. A full video is on Vimeo > IdeesfixVIII Gori propeller. This makes mooring a bit tricky, we need to manually pull IdeesfixVIII into the morring in reverse. The temperatures are now reaching 40C, and the engine is maybe battling a bit.